Recent Work
In the field, on job sites like yours.
Aftercooler Fan Motor Replacement
A destroyed aftercooler fan at a sand plant shut down cooling. We installed a new motor and fan on site and had the compressor back online the same day.
New Compressor Install at a Corpus Christi Cement Plant
We set the unit, ran new piping, tied it into the existing air line, and completed a full 4,000-hour service in the same trip.
Zeks Refrigerated Dryer Service
A low suction pressure alarm on a Zeks 3000HSG at a large cement plant. We diagnosed low refrigerant, did a full recovery and R410A recharge, and got the dryer back to spec.
FS Curtis Rotary Screw Tune-Up
Cooler swap, thermostatic valve replacement, new inlet valve, and a long-overdue air filter, all in one visit.
Desiccant Dryer System for a Laser-Engraving Shop
Air quality problems were hurting a laser-engraving process. We specced and installed a new desiccant dryer system sized for the whole facility, running alongside their FS Curtis compressor.
Compliant Condensate Drain Routing
Auto drains were dumping oil-laden condensate onto the concrete. We installed proper drain routing into compliant collection.
FS Curtis Vacuum Pump and Receiver Tank
A new FS Curtis rotary screw vacuum pump and IOS pressure vessel, sold, installed, and piped, ready to run from day one.
Plugged Separator Emergency Call
A Chicago Pneumatic compressor shut down on high temp within seconds. The separator element was completely plugged from skipped PM; we replaced it and got it running.
Second Opinion: Locked-Up Air-End
The customer was told it was bad starters. Our tech found a locked-up air-end within an hour, and within three hours we had it split from the motor and headed to our rebuild shop.
150 HP Motor Replacement
A worn drive coupling missed by a previous provider took out a bearing and shorted the motor. We confirmed it with insulation testing and replaced the motor.
